Wall thickness
The wall thickness of injection-moulded parts needs to be observed
properly to avoid potential problems such as leaving sink marks and letting
your part warp. At ALNO we recommend
different thicknesses depending on the material you are using and the eventual use
of your final product.
Surface finish
The finishes available to you at ALNO product services vary according to
you intended use and can range from all ranges of cosmetic finishes, EDM or
higher-end finishes.
Radii
ALNO uses an automated CNC milling process to create the mould for your
parts. However, some part edges will end
up with a radius rather than a sharp corner or edge. This does not typically involve
the need to change a model, but the designer should be aware of these before
moulds are made.
ALNO product services manufactures all your parts locally in our workshop
on the New South Wales Central Coast. We
provide innovative solutions and high-speed solutions so contact us today for a
quote.
No comments:
New comments are not allowed.